Dunbar Rd./ I-75

MDOT Historic Bridge Monroe County Dunbar Rd./ I-75

County: Monroe

City/Township: Monroe Twp.

Location: Dunbar Rd./ I-75

Year Built: 1955

About this Bridge:
The four-span Dunbar Road Bridge, which is skewed, crosses lanes of I-75 and a median. Piers are concrete with three arched openings. The two-lane-wide deck is carried by six T-beams. The bridge displays standard State Highway Department railings consisting of metal panels between concrete posts. Bridge plates are affixed at the northeast and southwest corners. The structure is located just south of the Monroe city limits.

Built in 1955, this structure is one of 37 bridges and grade separations constructed for the Detroit-Toledo Expressway by June 1956. The contractor for this project was W.H. Knapp Company of Monroe which submitted the low bid of $118,676.70. The new expressway was part of the state highway department’s emphasis on trunkline improvement and expressway development in the period which followed World War II.

The Detroit-Toledo Expressway was not the first important north-south road to traverse the eastern section of Monroe County. The Dixie Highway became the first highway in Michigan in 1829. This dirt road was built a short distance to its west. Both roads are still in use, but have mainly carried local traffic since the opening of I-75 in 1956.

It was hoped that the new expressway would relieve some of the heavy truck traffic clogging Telegraph Road. Although I-75 does not follow exactly the route of either of the earlier roads, the importance of traffic flow through the corridor is evident. Survey work for the new expressway was completed by June 1952, and bridge work on the approximately 25-mile route began during the 1953-54 biennium. The road bed and bridges and grade separations were designed to allow for the future addition of a third traffic lane in each direction. Of the interstate highways being built outside of the Detroit metropolitan area, the routes for I-75 and I-94 (Detroit to Chicago) were the furthest toward completion by the mid-1950s.

The state highway department first issued standard plans for concrete T-beam bridges during the 1913-1914 biennium. The design was used sparingly until the development of the interstate highway system in the 1950s and 1960s. By that time, curved beams were being used for greater under-bridge clearance.